Lactuca LT AP2
Soluble Cutting Oil.
Routine machining of non-ferrous metals and high-grade carbon steels. This product is specially designed for the machining of copper alloys and free cutting brass.
Ensure low degree of moisture of chips.
Recommended rate of use: 5% to 10% by volume
ISO 6743/7 : ISO-L MAA
Product SheetTOT_LACTUCA LT 2 AP_12-15_TDS
Safety Data SheetTOT Lactuca LT 2 AP 2018_SDS
Oil Intel MWF Coolant System Cleaner
Cleaner for soluble oil operated metalworking machines.
Developed for the cleaning of machines before draining.
Contains a blend of detergents, biocides and corrosion inhibitors.
Cleans by recirculating the MWF Coolant System Cleaner for a minimum of 8 hours before draining, flushing with fresh water and refilling with fresh machining coolant.
Provides temporary corrosion protection for system components during coolant change.
Neutralizes any objectionable odors from the coolant prior to maintenance operations.
Recommended dosage 1-3% depending on extent of fluid contamination.
After addition of MWF Coolant System Cleaner it is possible to continue machining without interruption for 8-12 hours.
Using MWF Coolant System Cleaner ensures the new coolant will be free from initial contamination providing improved coolant life and performance.
Compatible with most commonly used polymer hose and seal materials, and all metals commonly used for coolant system components.
Spirit WBF 5400
Multifunctional micro-emulsion for a wide range of metals.
SPIRIT WBF 5400 is recommended for workshops where there are wide variety of machining operations and materials.
SPIRIT WBF 5400 is particularly well adapted to difficult machining operations.
SPIRIT WBF 5400 is suitable for machining ferrous and non ferrous metals.
SPIRIT WBF 5400 gives very good results for flat, cylindrical and centreless grinding.
Recommended rate of use:
Grinding: 4 %
Light machining:5 to 7 %
Heavy machining: 6 to 9 %.
ISO 6743/7: ISO-L MAE
Product SheetTOT_SPIRIT WBF 5400_09-13_TDS
Safety Data SheetTOT Spirit WBF 5400 2018_SDS
Spirit WBF 7200
Micro-emulsion for difficult machining operations on a wide range of metals.
SPIRIT WBF 7200 is specially designed for difficult and very difficult machining operations.
SPIRIT WBF 7200 is intended for machining ferrous and non ferrous metals, hard steels, steel alloys, stainless steels, titanium, aluminium and alloys.
Recommended rate of use:
Heavy machining: 5 to 7%
Very heavy machining: 7 to 10%.
ISO 6743/7: ISO-L MAF
Product SheetTOT_SPIRIT WBF 7200_09-11_TDS
Safety Data SheetTOT Spirit WBF 7200 2018_SDS
Vulsol MSF 5200
Synthetic cutting fluid for ferrous and hard metals grinding.
VULSOL MSF 5200 is suitable for grinding all ferrous and hard metals.
VULSOL MSF 5200 is especially well-suited for grinding rolling cylinders.
Recommended rate of use: 3 – 4%.
ISO 6743/7: ISO-L-MAG
Product SheetTOT_VULSOL MSF 5200_04-11_TDS
Safety Data SheetTOT Vulsol MSF 5200 SDS